JC090 Remote type Pipe Magnetic Flow meter is a kind of inductional instrument designed by Faraday’s law of electromagnetic induction to measure flow of conductive media in the tube. It adopts the technology of insertion of single chip to realize digital excitation and employs CAN local fieldbus.
JC090 Remote type Pipe Magnetic Flow meter
Electromagnetic flowmeter is a kind of inductional instrument designed by Faraday’s law of electromagnetic induction to measure flow of conductive media in the tube. It adopts the technology of insertion of single chip to realize digital excitation and employs CAN local fieldbus.
Electromagnetic flow meter can realize local indication and output electrical current signal of 4-20mA which can be used to record, adjust and control. Electromagnetic flow meters are widely used in industrial sectors such as chemical industry, environmental protection, metallurgy, pharmaceutical, paper making, water supply and removal etc.
Besides measuring flow of general conductive liquid electromagnetic flowmeter can measure flow of liquid-solid mixed fluid, high-viscosity fluid and salt, strong acid and strong alkali.
Smart electromagnetic flow meters consist of sensor and smart signal transducer. And it can be classified into two structures--- integral type and remote type according to the set-up form of the sensor and transducer. In terms of integral type electromagnetic flow meters, transducer and sensor directly assembles as a whole and can not be dissociated. It is usually used at the scene where the environmental situation is good. To remote type electromagnetic flow meters transducer composes a product through a special electric cable and sensor. The sensor is installed at the scene and the transducer is installed in the place where the conditions are good. It is usually used at the scene where the environmental situation is poor, such as underground wells, high temperature and the place where people can not reach.
Technical Parameter for JC090 Remote type Pipe Magnetic Flow meter
DN10~DN2600 (below DN25 non-standard,which should be customized)
316L (stainless steel), Hastelloy C, Hastelloy B, Titanium, Tantalum
Liquid with conductive ratio more than 5 μs/cm
0.1~10m/s (extendable to 15m/s)
Upper Limit of Span
0.5~10m/s. 1~5m/s recommended
4~20mADC, load<= 750ohm, 0~3kHz, 5V with source and changeable width.
high terminal and effective frequency output , RS485 interface
1.0MPa, 1.6MPa, 4.0MPa, 16MPa (special)
-20C~80C, 80C~130C,130C~180C Depending on Lining Material
Sensor -40C~80C. transducer -15C~50C
<= 85%RH (at 20C)
Cable Outlet Size
220VAC±10%, 50Hz±1Hz, 24VDC±10%
Integral type: IP65. remote type: sensor IP68,transducer IP65
Materials of Liner
PTFE, soft rubber, hard rubber, PFA, etc
Flange :ANSI , DIN , JIS ,ISO ,GB standard
Thread :NPT ,BSP ,G
316L (stainless steel), HC, Ti, Ta, Cu
Carbon steel , 304SS , 316SS
Model Selection for JC090 Remote type Pipe Magnetic Flow meter
|Code||Nominal Diameter (mm)||Flow Range|
Material of liner
PTFE (F4 or Teflon)
How to to order
How to order
3.Flow rate (min/normal/max)
8.Other special requirement